Morphy Richards Hand held vacuum cleaner manual Pre Motor filter, Exhaust filter O

Hand held vac rev 3 73106/07 4/11/05 1:32 PM Page 7

•Always disconnect the cleaner from the mains when checking or replacing the filters.

•Always make sure the filters are fitted correctly before use. Failure to do so may result in damage to your product.

Pre Motor filter

The pre-motor filter Ú can be found by opening the dust compartment › using the dust compartment release button fl

Remove pleated hepa filter Ô and mesh filter. Remove the pre-motor foam filter Ú from its securing tabs and clean or replace.

Replace the foam filter Ú over the small tabs making sure it’s located correctly N

Exhaust filter O

The exhaust-filter Û must be cleaned regularly to remove the fine dust particles collected. This can be done by shaking it. The exhaust filter is located behind the exhaust filter covers fi. To remove, push

down on the tab and remove the cover. Pull out the foam filter Û and clean or replace

Using the blower function

1Remove the exhaust filter cover fi and foam exhaust filter Û

2Push and twist clockwise P the blower connector Ê into the back of the cleaner to lock into place.

3Attach the hose · to the correct end of

the blower connector Ê.

4The blower function can be used for a variety of uses including blowing dust

from delicate surfaces and also drying pet fur.

If using to dry pet fur:

•Never use the product in a wet environment.

•Do not use if the animal is frightened or distressed.

•Never leave the product alone with the animal. Never allow the animal to chew the product.

N

O

P

7