Quick start
1Assemble the nozzle, telescopic tubes and hose as shown A.
2Pull out the mains cable to it’s full length and plug in to the mains supply.
3Switch on by pressing the foot pedal fi.
Accessories
1Fit the hose to the cleaner by inserting the hose end into the hose inlet ⁄. When removing, squeeze the clips either side and pull.
2Attach the telescopic tubes to the handle end of the hose. Extend to the required length by pressing down the slider release Ê and pulling out the tube B.
The hose handle features a regulator È which allows the suction to be reduced as required.
3Attach the combination floor nozzle  to the tubes.
The crevice tool (for awkward places,
behind radiators etc.) and the upholstery brush (for curtains and upholstery) are stored on the tubes. The crevice tool has a
Controls
Power
The on/off control is operated by the foot pedal fi.
Variable power control
A rotating dial ‡ varies the suction power as required. For example, maximum suction can be used for cleaning carpets, hard floors etc. and reduced suction for cleaning upholstery and curtains.
Suction can also be controlled using the airflow control on the handle È. Closed for maximum suction, open for reduced suction.
Automatic cable rewind
After use, unplug and press the cable rewind button › to retract the cable.
WARNING: When using the cable rewind, always hold the plug as the cable will rewind quickly.
B
Ê
C
Á |
