Morphy Richards Precise Steam Iron FILLING A, FEATURES OF YOUR IRON, Temperature indicator light, Dry ironing, Spray C, TEMPERATURE, CONTROL B, Automatic variable, steam B

40725 rev3 14/8/06 14:03 Page 5

A

B

FILLING A

1Make sure that the iron is not

plugged in, then set the steam

to dry iron selector switch ⁄ to the position before filling the iron with water.

2Lift up the filler cap and fill the tank ‡ with water through the filling hole ‰, using the beaker provided (300ml). A Â After filling replace the filler cap. In hard water areas the use of distilled or demineralised water is recommended.

WARNING: Never use battery topping up fluid or water containing any substances like starch, or

sugar, or defrosted water from a refrigerator.

3 Always pour out the remaining water after use.

WARNING: When filling your iron with tap water always use the beaker provided. Never fill directly under the tap.

FEATURES OF YOUR IRON

Temperature indicator light

The indicator light fl shows that the iron is warming up. When the required temperature is reached the light will go out and will cycle on-off during operation.

Dry ironing

You can use your iron as a dry iron only. Make sure the steam to dry iron selector switch ⁄ is set to the symbol.

Any temperature setting may be used depending on the garment. The spray feature may be used provided there is water in the tank (see filling section). You do not need to put any water in the tank when dry ironing only.

Spray C

C

TEMPERATURE		Press the spray button › and
CONTROL B		aim the spray of water at
		stubborn creases. You can do
Plug in the iron and switch on.
		this whilst dry ironing providing
Set the temperature control dial		there is water in the tank. When
¤ to the temperature required,		using the water spray it may be
but don’t start ironing		necessary to push the button a
immediately.		few times to get the spray pump
If you wait a few minutes, the		primed.
iron will stabilise at the required		Automatic variable
setting. Your Morphy Richards
iron is fitted with an indicator		steam B
light fl which will go on and off
while you are ironing.		Fill the iron with water as
This is perfectly normal as it		described in the filling section,
		and insert the plug into the
shows that the iron is		electrical socket.
maintaining the heat setting you	1 Set the ‘steam to dry iron’
have chosen.
It is always a good idea to begin		selector switch to steam ⁄.
	2 Select the temperature required
with cool fabrics and work up to
higher settings.		by turning the temperature
		control dial ¤ to the desired
An iron heats up quicker than it		setting. The amount of steam
cools down so you’ll save time		required is automatically
and electricity.		selected and is displayed in
		window ‹.
		Press the shot of steam button
		fi to obtain a burst of extra
		steam for ironing out creases in

www.morphyrichards.com 5