Morphy Richards Steam Generator manual Anti-scale system, Filling the spray unit, Steam function

42271 rev4 30/7/08 15:56 Page 6

Filling the spray unit

The spray feature ‰ is lightly secured to the handle. To fill the water tank, pull the spray unit forward using the two moulded lugs provided.

Remove the spray bottle  from the base of the pump and fill with water to the ‘MAX’ mark.

Re-fit the spray bottle, making sure the arrows (printed black) are in line.

To replace the spray unit

Align the spray unit with the front of the iron.

Fit the bottom location leg into the slot at the front of the handle. Pivot the spray unit towards the iron, making sure it clips firmly in place.

Anti-scale system

The anti-scale cartridge is designed to reduce the build-up of limescale which occurs during steam ironing, this will prolong the working life of your iron. However, please note that the anti-scale cartridge will not completely stop the natural process of limescale build-up.

Replacing your anti-scale cartridge How often you need to replace your anti-

scale cartridge depends on how often you use your iron with it’s steam functions and how ‘hard’ your water supply is. Water hardness varies greatly from one area to another. For advice on the relative hardness of your water, contact your local water supplier.

If you spend an average of two hours per week ironing, then we suggest you refill your anti-scale cartridge as shown below:

Water hardness	Soft	Medium	Hard
Refill interval	6	3	11/2
(months)

If you iron more or less frequently, then you should alter the interval between refills accordingly.

Replacement anti-scale refills

To obtain replacement anti-scale refills, telephone our spares number on:

0844 873 0719.

1If a new cartridge is not available, you may continue operating the appliance but scale will build up in the system. Replace the used cartridge as soon as possible.

2Disconnect the appliance from the mains outlet.

3Slide out the tank and remove the anti-scale cartridge as shown E.

E

4Pull the plate from the end of the cartridge F.

5Remove the foam pad G.

6Place the refill into the cartridge, reposition the foam pad

and clip the plate onto the cartridge, making sure it

locks in position H. H

Features of your
steam generator	G
Temperature indicator light	F
The indicator light shows
that the iron is warming up.

When the required temperature is reached, the light will go out and will cycle on-off during operation.

Steam function

During the steaming process, small amounts of water may be ejected from the soleplate. This is normal and can be avoided by using the steam for short amounts of time and only when the iron is at the correct temperature (the indicator light on the iron goes out when ready).

6