VC71067MUK Rev5_Instruction Book 19/09/2012 13:40 Page 4
Operating / Assembly
1 | 2 |
Push the 360° rotating head on the hose (3) into the hose inlet (4) on the vacuum cleaner.
To remove, press the buttons on the hose connector and pull out.
3
Always pull out the power cord (11) to its maximum length (indicated by the yellow tag on the cable). Plug the appliance into the mains supply. Push the On/Off button (9) to start the motor.
IMPORTANT: Ensure that the appliance is never left unattended whilst it is switched on.
5
During short breaks in cleaning, the tube(s) (2) can be held in an upright, ‘standby’ position. Rotate the floor nozzle (23) or (28) until the lug on the neck can be fitted into the tube standby slot (12) on the rear of the appliance, whilst you move furniture for instance.
4
Attach either the extension tubes or the telescopic tube (2) (dependent on model) to the handle end (1) of the hose (3). Extend the telescopic tube to the required length by pressing down the tube release button and pulling out the tube. Attach the required accessory to end of the tube.
Close
Open 4
The suction power can be varied to suit the surface being cleaned by using the Eco Switch (10), (see the table on page 5 for guideline settings).
The suction power can also be adjusted using the suction control (1) on the hose handle.
Closed: full suction
Open: reduced suction
6
Switch off the appliance. Remove the plug from the mains supply and rewind the power cable using the cable rewind button (8).
WARNING: When using the cable rewind, always hold the plug as the cable will rewind quickly.
