Backplane Connectors | Controls, Indicators, and Connectors |
|
|
Backplane Connectors
ATCA−S100 is built for connection face plate. This section describes the backplane connectors.a
Zone 2 Connectors
Zone 2 of the backplane provides the two connectors P22 and P23. Except for some pins, the connector pinouts are as specified in the AdvancedTCA P23 and P22 specification. The following table shows which pins are reserved.aaaaa
Table 10: P23 Connector Pinouts
HBA FC Port | Channel | Port | Pinout | Signal Name |
FC−A | 1 | 3 | P23.3e | Reserved |
|
|
| P23.3f | Reserveda |
|
|
| P23.3g | Reserved |
|
|
| P23.3h | Reserved |
FC−B | 2 | 3 | P23.1e | Reserved |
|
|
| P23.1f | Reserved |
|
|
| P23.1g | Reserved |
|
|
| P23.1h | Reserved |
FC−A | 5 | 3 | P.22.5e | Reserved |
|
|
| P.22.5f | Reserved |
|
|
| P22.5g | Reserved |
|
|
| P22.5h | Reserved |
FC−B | 6 | 3 | P.22.3e | Reserved |
|
|
| P.22.3f | Reserved |
|
|
| P22.3g | Reserved |
|
|
| P22.3h | Reserved |
Note:aIf the blade is to be adapted to specific needs, further connector pinouts may be useful to give information on which signal is assigned to which pin. Refer to AdvancedTCA specification.
ATCA−S100 | 47 |
