3 1/2 x 1/4 inch bolt
1/4 Flat Washer
1/4 Flat Washer
1/4 Lock Washer
1/4 Hex Nut
Note: All Hardware is Stainless Steel
Figure 2-5. C-Clamp Bracket Assembly
3. Position the bracket in the desired location and securely tighten the two bracket bolts.
4. If required, loosen the Pivot Bolt and the Angle Locking Bolt (Figure 2-6) so that the
antenna connector is positioned vertically.
5. Ensure that the antenna connector is still vertical and tighten the Pivot Bolt using a 7/16-
inch open-end wrench or socket wrench.
6. Tighten the Angle Locking Bolt using a #1 Phillips screwdriver.
8