Motorola 68000201472-C settings menu, let’s go, install the battery, charge the battery

		settings menu				let’s go
settings menu	Sounds		•	Call		let’s go
•						let’s get you up & running
	•	Call Ringtone		•	Answer Options
	•	Message Ringtone		•	Auto Retry	install the battery
	•	Voicemail Ringtone		•	TTY Setup
	•	Ring & Vibrate		•	One Touch Dial	1 Press the battery cover release
	•	Alert Reminders		•	Int’l Dialing
	•	Service Alerts		•	DTMF Tones	button. While still pressing the
	•	Power On/Off		•	Hearing Aid	button, slide the cover down
	•	Voice Readout	•	USB
						slightly until it pops up, then lift
	•	Keypad Volume			Mass Storage
	•	Volume Sidekeys		•		it off the phone.
				•	Modem/COM
•	Display
			•	Bluetooth
	•	Banner
	•	Backlight		•	Add New Device
	•	Brightness	•	Storage Device
	•	Wallpaper
				•	Save Options *
	•	Skins
				•	Phone Memory
	•	Dial Fonts
				•	Memory Card *
	•	Clock Format
			•	Phone Info		2 With the gold contacts facing
•	Phone
						down and toward the lower end
	•	Airplane Mode	* available only when optional memory
	•	Shortcuts				of the battery, insert the battery,
			card installed
	•	Language				lower end first.
	•	Location
	•	Security

•Network Selection

•Active Line

•Text Learning

7 8

let’s go	let’s go
3 Fit the battery cover back onto	When you charge the battery, the battery level indicator
the phone and slide it forward	at the upper right of the screen shows charging
into place.	progress. At least one segment of the indicator must be
	visible to ensure full phone functionality while charging.
charge the battery	Charging from your computer:
	Note: Optional accessories required. You can charge
New batteries are not fully charged. Before you can use
	the battery by connecting a cable from your phone’s
your phone, install and charge the battery. Some	micro USB port to a high-power USB connector on a
batteries perform best after several full charge/discharge	computer (not a low-power one, such as the USB
cycles.	connector on your keyboard or bus-powered USB hub).
Using the charger:	Typically, USB high-power connectors are located directly
	on your computer.
1 Insert the charger into your
	Both your phone and your computer must be turned on,
phone’s micro USB
	and you must have correct software drivers installed on
connector. Plug the other
	your computer. Cables and software drivers are available
end of the charger into an
	in Motorola OriginalTM data kits, sold separately.
electrical outlet.
2 When you see Charge Complete, unplug the charger.	Note: For battery use and battery safety information, see
	your User’s Guide.

9

10