Motorola L802, L804 Setting the dial mode, Setting the flash time, Three-party conference call

3.14.3Three-party conference call

1. During an external call, press INT. - Your caller is put on hold.

2. Press VOL+ or REDIAL/VOL- to select the handset you want to call.

3. Press MENU to call the handset.

4. When the other handset answers the intercom call, press MENU on the calling handset to set up the conference call.

5. Press /BACK on any handset to end a three-party conference call and leave the other handset engaged with the caller.

NOTE

During an external call, pressing /FLASH or /SPEAKER on any handset will join in the call and set up

a conference call.

3.15Setting the dial mode

The default dialing mode is suitable for your country and network operator. It is unlikely that you should need to change this setting unless advised to do so.

20

1.Press MENU and then VOL+ or REDIAL/VOL- to select

SETUP BS.

2.Press MENU to select DIAL MODE.

3.Press MENU and then VOL+ or REDIAL/VOL- to select

TONE or PULSE.

4.Press MENU to save.

NOTE

If the pulse mode is selected, press TONE/* to switch from pulse to tone dialing temporarily when dialing out. After the call is ended, the dial mode will change back to pulse.

3.16Setting the flash time

The default flash time is 600MS. It is unlikely that you should need to change this setting unless advised to do so.

1.Press MENU and then VOL+ or REDIAL/VOL- to select

SETUP BS.

2.Press MENU and then VOL+ or REDIAL/VOL- to select

FLASH TIME.

3.Press MENU and then VOL+ or REDIAL/VOL- to the flash time you want. (8 options are available : 90, 100, 110,

250, 300, 400, 600 and 700MS)

4.Press MENU to save.

Using the Phone