2.3Parent Unit Power Supply
ENGLISH
IMPORTANT
Installing the rechargeable battery pack and charging it fully before use is recommended. This will allow the unit to operate on battery in the event of a power failure.
1.Connect the small plug of the power adapter to the parent unit and the other end to the electrical outlet. Only use the enclosed power adapter (6V DC/500mA).
2.Press and hold the P POWER ON/OFF button for 1 second to turn ON the parent unit.
3.Once the baby and parent units are switched on, the display on the parent unit will show the video captured by the baby unit.
4.If there is no connection or you are out of range, the video display will go off and the words No Signal will be shown on the LCD display, and the unit will beep every 5 seconds. Move the parent unit closer to the baby unit until the link is
5.Press and hold the PPOWER ON/OFF button, until the progress bar finishes scrolling, to turn OFF the parent unit.
NOTE |
|
|
The battery icon | 0 | turns RED to indicate that the battery is low, and it |
gives a beep every 16 seconds. The battery needs to be recharged. The battery pack takes about 16 hours to charge fully.
When charging
1. During power OFF, when adapter is plugged in, a adapter logo will display on screen and then a flashing battery logo will display for 45 sec. The Blue LED at top left corner light up indicates adapter is plugged in.
Getting Started | 9 |
|
|
