Setting the Interference Eliminator Code
To set the code, press \ twice until the code number display
begins to blink. Then press [ or ] to set the code. Press M to save the code setting. To hear everyone on your channel, select
code 0.
You can specify a different code for each channel. To set a channel and code combination, press \ and then press [ or ] to select the channel. Press \ again and then press [ or ] to select a code. Press M to exit the menu and to save the channel and code combination. To set another channel and code combination, repeat these steps.
Volume
You can set the volume whenever you are not using a menu. Press [ or ] until it’s just right. The display will show V and the volume
setting (1 to 20) with 1 being the lowest volume and 20 being the | 5 | |
highest volume. |
|
|
|
| |
Caution: Do not hold the radio too close to your ear when the volume is at a high setting. This could cause hearing damage.
Talking and Listening
29
