USB08 Quick Start
Starting the Windows Demo Application
USB08 Evaluation Board Designer Reference Manual
MOTOROLA USB08 Quick Start 25
By setting the check boxes on the upper right side it is possible to switch
on or off the LEDs of the demo board. The needle p ointer instrumen ts on
the lower side of the application window indicate the measured val ues of
the three variable resistors:
•Input 1 represents the photo sensor.
•Input 2 shows the thermistor value.
•Input 3 can be varied using the turnable regulator.
The USB08 evaluation board can be disconnected from the USB port
and reconnected at any time, because the drivers are automatically
activated or deactivated by the Windows operating system. The
activation/deactivation of the drivers can be watched in the operating
system’s device manager window (start button/settings/control panel/
system/device manager). The catalog entry USBIO controlled devices
and the device entry USB08 Evaluation Board are visible only if the
hardware is present. See Figure 1-8.
Figure 1-8. Driver Entry for USB08 in the Device Manager Window