Universal Serial Bus (USB) Interface
Data Communication via Endpoints EP1 and EP2
USB08 Evaluation Board Designer Reference Manual
MOTOROLA Universal Serial Bus (USB) Interface 77
after 10 ms the host asks whether further data has to be fetched from
endpoint 1 or not.
NOTE: In practice, the host uses only intervals of 2n ms, the demanded 10 ms
is then rounded to 8ms.
The USB interrupt routine is called cyclically and branches to the hand ler
handleIN1. From there, data is taken from the ring buffer TxBuffer (if
available) and transferred into the USB endpoint1 data registers
UE1D0–UE1D7. Subsequently, the number of bytes which should be
sent is registered in the fields TP1SIZ3–TP1SIZ0. If no data is in the
buffer, this number is registered as 0. The T1SEQ bit is inverted to switch
between DATA0 and DATA1 packets (data toggle). Finally, by setting
the bit TX1E in the USB control register 1 (UCR1), the transmission of
the data is enabled.
The operation mode selected here is based on a continuous data
stream. If there is no transmit data in the buffer, the device will send data
packets with zero byte contents. If this condition continues for a longer
time, sending of empty data packets means a waste of bus bandwidth.
If this turns out as critical, a change of the operation mode is
recommended. Alternatively, it is possible to disable TX1E, as long as
no data is present in the buffer. Then, the endpoint answers a polling
only with a NAK packet and does not occupy any additional bandwidth
by sending an empty data packet.
Bit 7654321Bit 0
Read: T1SEQ STALL1 TX1E FRESUM TP1SIZ3 TP1SIZ2 TP1SIZ1 TP1SIZ0
Write:
Reset:00000000
= Unimplemented
Figure 4-11. USB Control Register 1 (UCR1)