Operation
SAFETY HARNESS
A
push
B
C
1
To fasten waist strap push both buckle ends A & B into the crotch buckle C.
DE
clip here
2
Clip shoulder straps D & E to waist strap buckles.
SEAT ANGLE
TERRAIN ZIP HAMMOCK OPTION
The Zip Hammock has two seat back positions. Seat back is upright when zips are up, and reclined when zips are down.
ADJUSTING SHOULDER STRAP HEIGHT
1
insertion
slit
buckle
Shoulder straps should be adjusted so they are located just below or level with a
sliding sliding
buckles buckles
2
3
shoulder
straps
child’s shoulders. The older the child, the further up the seat these straps will go.
| 3 | 4 | 5 |
A d j u s t | s l i d i n g | Move sliding buckles | To release, press |
buc kles | so the | up as far as possible | sides of centre |
harness straps are | to reduce the amount | buckle. | |
a firm fit. |
| of strap hanging |
|
|
| loose, eliminating the |
|
|
| risk of chocking. |
|
A separate safety harness conforming to British Standard BS6684 may be attached to the two “D” rings located at the insertion of the waist harness.
SEAT ANGLE
ALL MODELS
strap | To locate buckle when adjusting |
| straps, slip your hand up the |
| inside back of the seat (or |
| inside the pocket on the Zip |
buckle | short side Hammock model). |
Seat back can be reclined to any point between upright and fully reclined position.
REMOVING
With a hand inside the back of the seat rotate the rectangular shaped buckle and push short side through the insertion slot, while pulling strap at the front.
INSERTING
buckles
strap |
|
To adjust: Pull on buckles to | Shows upright through to |
slide straps through buckles | fully reclined seat angle. |
and recline seat. Pull straps |
|
through buckles to raise |
|
seat angle. |
|
NOTE: The stroller would become unstable if a child was to move up the seat. For this reason the seat retains a slight angle to prevent the stroller from tipping back.
POSITION OF CHILD IN SEAT
X | Make sure baby |
is positioned | |
down as far as | |
| possible in seat. |
CORRECT XWRONG
6