For UNIX Users ∙ | ∙ Chapter 4 |
|
|
1. | /dev/fd0135ds18 | (A: 1.44MB) |
2. | /dev/fd096ds15 | (A: 1.2 MB ) |
3. | /dev/fd1135ds18 | (B: 1.44MB) |
4. | /dev/fd196ds15 | (B: 1.2 MB ) |
5. | /tmp/moxa | (Hard Disk ) |
Select :
For ...
Tar files from driver diskette, please wait ...
Then the MOXA Multiport Board Installation Utility will show for board installation.
Follow the instructions prompted to install.
Step 5. Now user may shutdown the system and reboot. If user has trouble in booting the new UNIX kernel, use the backup kernel (/unix.moxa) to boot the system. The system will work as before. Refer to Appendix A Troubleshooting.
After the system starts up again, enter into the multiuser mode. The following message will show:
MOXA C360 SuperPort System Communication Driver (Ver. x.xx) Setup driver ...
C360 Control Board 1: base I/O address [200] IRQ 10 Async Concentrator's serial no. : 101
Device Driver Setup O.K.
If the following error message appears
C360 Control Board 1: base I/O address [220] not found!
C360 Control Board 2: base I/O address [240] found no concentrator! Please see Appendix A Troubleshooting.
19
