ThinkCore W311/321/341 Linux User’s Manual Getting Started

2-2

Powering on the W311/321/341
Connect the SG wire to the shielded contact located in the upper left corner of the W311/321/341,
and then power on the computer by connecting it to the power adaptor. It takes about 30 to 60
seconds for the system to boot up. Once the system is ready, the Ready LED will light up.
NOTE After connecting the W311/321/341 to the power supply, it will take about 30 to 60 seconds for
the operating system to boot up. The green Ready LED will not turn on until the operating
system is ready.
ATTENTION
This product is intended to be supplied by a Listed Power Unit with output marked “LPS” and
rated for 12-48 VDC, 600 mA (minimum requirements).
Connecting the W311/321/341 to a PC
There are two ways to connect the W311/321/341 to a PC: through the serial console and by
Telnet over the network.

Serial Console

The serial console gives users a convenient way of connecting to the W311/321/341. This method
is particularly useful when using the computer for the first time. The serial console is useful for
connecting the W311/321/341 when you do not know either of the two IP addresses.
Use the serial console port settings shown below.
Baudrate 115200 bps
Parity None
Data bits 8
Stop bits: 1
Flow Control None
Terminal VT100