Moyer Diebel 401-HTM2 PLUS, 401-HTNM2 PLUS Installation, Unpacking, Electrical Connections

INSTALLATION

INSTALLATION

Unpacking

WARNING:

!Care should be taken when lifting the machine to prevent damage.

1.Immediately after unpacking your machine, inspect for any shipping damage. If damage is found, save the packing material and contact the carrier immediately.

2.Remove the dishwasher from the skid. Adjust the feet if required, then move the machine to its permanent location.

3.Level the machine (if required) by placing a level on the top of the machine and adjusting the feet. Level the machine front-to-back and side-to-side.

CAUTION:

!After locating your machine, the installation must meet local health codes. An example may be to seal your machine to the floor using a good grade of silicone sealant.

Electrical Connections

WARNING:

!Electrical and grounding connections must comply with the National Electrical Code and/or Local Electrical Codes.

WARNING:

!When working on the dishwasher, disconnect the electric service and tag it to indicate work is being done on that circuit.

1.The electrician should compare the electrical specifications on the machine electrical rating label (located on the lower left front panel) to the electrical power supply before connecting the machine to the incoming service at a fused disconnect switch.

NOTE:

The 208-240V/60Hz/1PH electrical supply service for this machine must be a 3-wire plus ground service.

2.On the 208V-240V models, a terminal block is provided on the left front side of the machine (located behind the front panel) for electrical service connections. A fused disconnect switch or circuit breaker (supplied by user) is required to protect each power supply circuit.

3.On 115V models, your machine is already equipped with a 4-foot power cord and plug suitable for 115V-15A service.

5