Mr. Coffee ESX20 manual Brewing Coffee Later, Programmable Features, Brewing 1 4 Cups

Brewing Coffee Later

For Programmable Models (ESX20, ESX23, ESX39 & ESX40):

You must set the time for when you would like the coffeemaker to begin brewing your coffee.

1. Press and hold the SET DELAY button.

2.While pressing and holding the SET DELAY button, press and hold the HOUR button until the clock displays the hour you desire. The PM indicator will light to indicate a PM time; if the PM indicator is not lit, the time is AM.

See Figure A-1.

3.While still pressing and holding the SET DELAY

button, press and hold the MIN. button until the clock displays the correct minute.

See Figure A-2.

4.Release the SET DELAY button. The DELAY BREW time is now set.

5.To activate Delay Brew:

For ESX20 and ESX23:

Press the DELAY BREW button. The Delay Brew indicator light will illuminate. See Figure B-1.

For ESX39 and ESX40:

Press the SELECT button until the Delay light is illuminated. See Figure C-1.

Due to a safety feature included in this unit, the Delay Brew mode will not automatically brew the next day after its last use. If you want your coffee to brew at the same time the following day, simply add the desired amount of ground coffee, fill the water reservoir and repeat Step 5 above.

6.To cancel Delay Brew:

For ESX20 and ESX23:

Press the DELAY BREW button. The Delay Brew indicator light will turn off.

For ESX39 and ESX40:

Press the SELECT button until all indicator lights are off.

FIGURE A-1

FIGURE A-2

FIGURE B-1

FIGURE C-1

Programmable Features

(Models ESX39 & ESX40 Only)

Brewing 1 – 4 Cups

If you want to brew 4 cups or less, the 1 – 4 Cup mode will slow the brewing cycle to ensure optimal saturation of the ground coffee. Note: If this mode is selected when brewing more than 4 cups, it will produce stronger, darker coffee.

To Brew 1-4 Cups Now:

Press the SELECT button until the 1-4 Cup indicator light is illuminated.

To Delay Brew 1-4 Cups:

Follow steps 1-4 in the “Brewing Coffee Later” section. Press the SELECT button until both the Delay and 1-4 Cup indicator lights are illuminated.

Adjusting the Warmer Plate Temperature

After the coffee is brewed, you can keep the coffee at your preferred temperature. Turn the Warmer Temp knob clockwise to increase the temperature, or turn counterclockwise to decrease the temperature. To maintain a constant temperature, you may need to lower the warmer plate temperature as you decrease the amount of coffee in the pot. DO NOT allow the decanter to boil dry. This will damage the decanter.

Audible Ready Signals

When the coffeemaker is finished brewing and your coffee is ready, your coffeemaker will beep five times.

Just before the coffeemaker shuts off automatically, it	clean
will beep three times. Upon completion of the clean
cycle, the coffeemaker will beep once.

Special Cleaning Cycle

Follow steps 1-3 in “Maintaining Your Coffeemaker” (on Page 14) and then press the Select Button until the Clean indicator light is illuminated. For your convenience,

cleaneverything is automatic. The entire cycle will take 45-60 minutes to complete. During the Cleaning Cycle your coffeemaker will:

1. Slow brew approximately 3 cups of cleaning solution.

2.Pause for 30 minutes (the Clean Cycle indicator light will remain on to alert you that the process is active).

3.After 30 minutes, your coffeemaker will brew the remainder of the cleaning solution.

4.When complete, the Clean light will turn off and your coffeemaker will automatically shut off and beep. Follow Steps 7-12 in “Maintaining Your Coffeemaker” (on Page 14) to complete the cleaning process.

12 13