Mr. Coffee PM, PR6 manual Automatic Pause ‘n Serve, Cleaning Instructions, Vpe of Water

Automatic Pause ‘n Serve

For your convenience, our Pause ‘n Serve feature allows you up to 30

SECONDS to sneak a cup while the coffee is still brewing. -

TO PREVENT INJURY FROM HOT OVERFLOW, REPLACE DECANTER WITHIN 30 SECONDS IF REMOVED DURING BREWING.

Cleaning Instructions

Your coffeemaker must be cleaned when you begin to notice excessive steaming or the brag time increases considerably. This condition is caused by a buildup of lime and mineral deposits from your water. If the pumping action stops before all the water has been pumped out of the machine, then the appliance requires cleaning.

The frequency of cleaning depends on the hardness of water used. The following table gives you the suggested cleaning intervals.

SUGGESTED CLEANING INTERVAL

vpe of Water	Cleaning Frequency
Soft water	every 80 brew cycles
Hard water	every 40 brew cycles

Your coffeemaker may be cleaned by using MR. COFFEE CLEANER or vinegar. For best results use MR. COFFEE CLEANER. It is superior to vinegar and has no unpleasant odor.

Using Mr. Coffee Cleaner

(Read caution statement on side panel of Mr. Coffee Cleaner box before use)

1.Fill the decanter to the bottom of the silver band with warm water.

2.Empty contents of one packet of MR. COFFEE CLEANER into the decanter and stir until the cleaner is completely dissolved. This will make a clear blue solution.

3.Pour the blue solution into the coffeemaker.

4.Place the empty decanter on the warmer plate. The swing-out basket with the black filter basket in place should be closed.

5.Turn your coffeemaker on.

6.When the blue solution has stopped flowing, turn your coffeemaker off.

7.Discard the blue solution and thoroughly rinse the decanter, lid and black basket.