Mr. Heater #MH500PT Model, Btu, Operating Temperature Range Inlet Pressure, Assembly Instructions

OPERATING CHARACTERISTICS

Model

BTU

Operating

Temperature Range

Inlet Pressure

Range

MH500PT

500,000*

-10oF to 100o F

17 psi to 170 psi

* Tank size and tank temperature can directly affect BTU output

Assembly Instructions:

Un-assembledAssembled

1) Unpack all the components and inspect for any damage. If any damage is discovered contact the delivery service or Mr. Heater immediately.

2)Connect the hose assembly to the handle assembly and tighten counterclockwise.

NOTE: This is a left-handed thread connection.

Connection to the Supply Tank:

NOTE: The LP (Liquid Petroleum) gas tank used with this device should be no less than a 20 lb. capacity. It should also meet or exceed NFPA 58 “Standard for the Storage and Handling of Liquefied Petroleum Gases”.

1)Inspect the nut/nipple (excess shut-off valve) connection of the hose assembly. Check for any dents or damage. The o-ring must be present. If damage is found or the o-ring is missing call Mr. Heater for the proper replacement parts.

2)Connect the excess shut-off valve end of the host assembly to the shut-off valve of a LP gas tank and tighten counterclockwise.

NOTE: If your LP gas tank does not have a shut-off valve, exchange the tank for one with a shut-off valve.

CAUTION:

This device is designed for vapor withdrawal from an LP gas tank(s) ONLY. Use of any other gas may result in device failure or personal injury.

Mr. Heater Propane Torch 4 Operating Instructions and Owner’s Manual