I X . D I S A S S E M B LY A N D A S S E M B LY
ASSEMBLY
1.Position the front and rear sections of yourscooter as shown in figure 22.
2.Use the tiller handle to lift the front section as you align the lower slots of the front section with the correspond- ing pegs on the front of the rear section. See figure 21.
3.Holding the seat post, slowly pivot the rear section forward until the curved locking brackets are fully con- nected onto the top rear pegs. See figure 20.
4.Raise the tiller and fully tighten the tiller adjustment knob.
5.Secure the toggle latch. See figure 18.
νLower the toggle latch buckle.
νPush back on the toggle latch so it locks into place.
6.Connect the
7.Replace the battery compartment lid.
8.Replace the seat and rotate it until it locks into place.
9.Unlock the front wheel by turning the tiller lock knob 90° counterclockwise. See figure 16A.
WARNING! After assembling your scooter make absolutely certain the tiller lock knob is in the unlocked position before attempting to ride your scooter.
32 | www.pridemobility.com | Sonic/RevA/May 2004 |
