Equipment Checklist, Mounting | MRV Communications MR2228-S2C

Figure 3-1. RJ-45 Connections

Equipment Checklist

After unpacking this switch, check the contents to be sure you have received all the components. Then, before beginning the installation, be sure you have all other necessary installation equipment.

Package Contents

•Stackable Fast Ethernet Switch (MR2228-S2C)

•Four adhesive foot pads

•Bracket Mounting Kit containing two brackets and eight screws for attaching the brackets to the switch

•Power Cord—either US, Continental Europe or UK

•RS-232 console cable

•This Installation Guide

•Management Guide

Optional Rack-Mounting Equipment

If you plan to rack-mount the switch, be sure to have the following equipment available:

•Four mounting screws for each device you plan to install in a rack—these are not included

•A screwdriver (Phillips or flathead, depending on the type of screws used)

Mounting

This switch can be mounted in a standard 19-inch equipment rack or on a desktop or shelf. Mounting instructions for each type of site follow.

14

Image 18

MRV Communications MR2228-S2C manual Equipment Checklist, Package Contents, Optional Rack-Mounting Equipment

Contents

Stackable Fast Ethernet Switch Installation Guide Installation Guide Contents Appendix B Cables Switch Architecture IntroductionOverview 10BASE-T/100BASE-TX Ports Description of HardwareNetwork Management Options 1000BASE-T/SFP Ports Stacking Ports Port and System Status LEDs Port Status LEDs Condition Status Power Supply Receptacles System Status LEDs Expandability Features and BenefitsConnectivity Performance Management Application Examples Introduction to SwitchingNetwork Planning Collapsed Backbone Network Aggregation Plan Collapsed Backbone Remote Connections with Fiber Cable Network Aggregation Plan Making Vlan Connections Remote Connections with Fiber Cable Application Notes Making Vlan Connections Installing the Switch Selecting a SiteEthernet Cabling Mounting Equipment ChecklistPackage Contents Optional Rack-Mounting Equipment Rack Mounting Attaching the Brackets Desktop or Shelf Mounting Attaching the Adhesive Feet Installing an Optional SFP Transceiver Connecting Switches in a Stack Connecting to a Power Source Connecting Switches in a Ring-topology Stack Connecting to the Console Port Wiring Map for Serial Cable DTE Port Making Network Connections Connecting Network DevicesConnecting to PCs, Servers, Hubs and Switches Twisted-Pair Devices Network Wiring Connections Making Twisted-Pair Connections Network Wiring Connections Fiber Optic SFP Devices Connectivity Rules 1000BASE-T Cable Requirements Mbps Fast Ethernet Collision Domain Cable Labeling and Connection RecordsMbps Gigabit Ethernet Collision Domain Mbps Ethernet Collision DomainPage Power and Cooling Problems Appendix a TroubleshootingDiagnosing Switch Indicators Table A-1. Troubleshooting Chart Symptom Action Installation In-Band AccessStack Troubleshooting Appendix B Cables Twisted-Pair Cable and Pin Assignments10BASE-T/100BASE-TX Pin Assignments Straight-Through Wiring Crossover Wiring 1000BASE-T Pin Assignments Cable Testing for Existing Category 5 Cable Adjusting Existing Category 5 Cabling to Run 1000BASE-TFiber Standards Appendix C Specifications Safety Forwarding ModeManagement Features In-Band Management Throughput Bandwidth 1000BASE-TAuto-Negotiation Collision Switched Ports Media Access Control MACRJ-45 Connector Ieee 802.3ab