Hardware Setup
Fan Power Connectors: CPUFAN0, SYSFAN1, AUXFAN0
The fan power connectors support system cooling fan with +12V. When connecting the wire to the connectors, always take note that the red wire is the positive and should be connected to the +12V, the black wire is Ground and should be connected to GND. If the mainboard has a System Hardware Monitor chipset
Sensor +12V GND
Sensor | GND | Sensor | GND |
+12V |
|
| +12V |
CPUFAN0 SYSFAN1 AUXFAN0
Important
Please refer to the recommended CPU fans at Intel® official website or consult the vendors for proper CPU cooling fan.
Front Panel Connectors: JFP1
The mainboard provides two front panel connectors for electrical connection to the front panel switches and LEDs. The JFP1 is compliant with Intel® Front Panel I/O Connectivity Design Guide.
| Reset | HDD | |
| Switch LED | ||
| + - - + | ||
JFP1 | 9 | 1 | |
10 | 2 | ||
| |||
- + Power Switch
Power/
Suspend
LED
JFP1 Pin Definition
PIN | SIGNAL | DESCRIPTION |
1 | HD_LED + | Hard disk LED + |
2 | FPPWR/SLP | Power LED + |
3 | HD_LED - | Hard disk active LED |
4 | FPPWR/SLP | Suspend LED + |
5 | RST_SW - | Reset Switch - |
6 | PWR_SW+ | PowerSwitch + |
7 | RST_SW + | Reset Switch + |
8 | PWR_SW- | PowerSwitch - |
9 | RSVD_DNU | Reserved. |
