![Attaching](/images/new-backgrounds/88308/8830811x1.webp)
3
Attaching
Bracket
Assembly
Model Series 600 through 619
Attaching The Bracket
Assembly
Model Series 600 through 619
IMPORTANT: Before assembly, place the tractor on a firm, level surface, disengage the PTO, stop the tractor engine and set the parking brake.
1. For convenience, pivot the seat forward and leave it in that position until the grass collector is fully mounted and assembled.
2. Position the hooked ends of the bracket assembly over the shoulder bolts (1). Swing in the bottom of
the bracket assembly down and in (2) over the hitch
plate and aligning with the hole on the hitch plate. Hitch Plate See Figure 5.
IMPORTANT:
Before assembly, place
the tractor on a firm,
level surface, disengage the PTO, stop the tractor engine and set the park- ing brake.
NOTE:
There are two holes in the clevis pin. Be sure to insert the hairpin clip in the upper hole
3.Insert the clevis pin (J in Fig. 4) through the aligned holes in both the bracket assembly and the hitch plate and secure with the hairpin clip (I in Fig. 4). Refer to Figure 6.
NOTE: There are two holes in the clevis pin. Be sure to insert the hairpin clip in the upper hole to properly secure the bracket assembly to the hitch plate.
Figure 5
Upper Hole
Figure 6
to properly secure the bracket assembly to the hitch plate.
Model Series 650 through 699
This graphic below coordinates with the instructions for the Model Series 650 through 699, which begin on the next page.
Screws | Support |
Removed | Bracket |
Earlier |
|
Outer Hole | Outside of Bracket |
Figure 7 | Figure 8 |