NOTE: To avoid damage to the memory carrier extraction handles, HP recommends rotating the handles inward and snapping them into the locked position when servicing the system DIMMs or any time the carrier is out of the chassis. Before replacing the memory carrier, press the button to release the extraction handles. Use the handles to replace the memory carrier into the chassis.
5.To locate the DIMM you need to remove, use Figure
Slot IDs” (page 210), or Figure
6.Lay the memory carrier assembly on side 0 or side 1 so that the memory board containing the DIMMs that require servicing faces upward (Figure
7.Remove the memory carrier assembly side cover.
a.Press the release tabs (Figure
b.Rotate the side cover slightly to free the tabs from the retaining slots at the base of the assembly (Figure
c.Lift the side cover off the assembly.
8.Release the DIMM from the slot.
a.Identify the DIMM you want to remove on the memory board.
b.Push the appropriate extraction levers found on either side of the DIMM slot outward to the open position (Figure
9.Remove the DIMM from the slot.
Figure
Figure
Release tabs
Extraction Handles (Closed)
Memory Carrier
Assembly Side cover;
Side 1
Extraction
Handles release
Button
Release
Tabs
Memory Carrier | Memory |
Assembly Side Cover; | Boards |
Side 0 |
|
Removing and Replacing the Memory Carrier Assembly 207