3.Deactivate the
a.Press the red attention button located on the MRL of the appropriate slot, and the power LED starts to blink.
b.Wait until the power LED goes from blinking to steady off.
NOTE: After pushing the attention button, you have five seconds to cancel the operation by pushing the attention button again.
4.Pull the gate latch toward the front of the chassis to completely unlock the
5.Open the MRL.
a.Press the indentation on the MRL to release it from the chassis wall.
b.Lift the edge of the MRL, and rotate it upward 90 degrees until it rests against the chassis wall and the
6.Disconnect all external and internal cables attached to the
7.Grasp the
8.Grasp the
CAUTION: When inserting the
Also, ensure that you fully seat the card into the slot or the card can fail after power is reapplied to the slot.
9.Insert the
10.Reconnect all internal and external cables to the
11.Close the MRL.
a.Rotate the MRL downward 90 degrees.
b.Push the edge of the MRL down until it clicks into place on the
12.Close the gate latch to secure the end of the card if it is
13.Activate the
a.Press the red attention button located on the MRL of the appropriate slot, and the power LED starts to blink.
b.Wait until the power LED goes from blinking to steady on.
NOTE: After pushing the attention button, you have five seconds to cancel the operation by pushing the attention button again. After five seconds, pressing the attention button initiates slot powerdown for online replacement (OLR) of the card.
14. Replace the top cover. See “Replacing the Top Cover” (page 182).
200 Removing and Replacing Server Components