8th drive load in bay 1
CAUTION: Drives are loaded in the factory, starting with number 8, working from right to left and bottom to top. If you have never changed your SAS configuration before, you can safely move SAS devices downwards as a block. If you have bays 6, 7, and 8 occupied you can move them down to bays 1, 2, and 3 without having the hardware paths change during a
TIP: When you receive an HP Integrity rx3600 or HP Integrity rx6600 server from HP, if you ever plan to add other SAS devices into the system, you should consider moving the SAS devices so they start in bay 1 going upwards instead of Bay 8 going downwards.
Replacing a Hot-Pluggable Disk Drive
NOTE: The replacement disk drive must have the same product number as the disk drive that you replace.
To install a
1.Use Figure
Figure
1 | 2 | 3 |
4 |
| 5 |
6 | 7 | 8 |
2.Remove the disk drive filler. See “Removing a
NOTE: Save the disk drive filler for future use. For cooling purposes, always place disk drive fillers in slots that do not contain a disk drive.
3.Insert the
4.Close the extraction handle by pushing it inward until it clicks into place.
5.Observe the following disk drive LEDs to ensure the drive is functional. For more information see
•Drive status LED
•Drive activity LED
Removing and Replacing PCI/PCI-X/PCIe Card Dividers
190 Removing and Replacing Server Components