HP INTEGRITY RX3600 manual Shell drvcfg -s drvrhandle cntrlhandle where

NOTE: The EFI driver’s handle values change on every boot.

TIP: From this command (drvcfg), record these two pieces of information for each channel of each SCSI interface for parameters to be changed:

•Drv(the EFI driver’s handle)

•Ctrl(the controller’s handle)

4.Using the driver’s handle [Drv] and the controller’s handle [Ctrl] from the

drvcfgcommand, start the EFI SCSI Setup Utility for one channel of this SCSI interface. At the EFI Shell prompt, enter:

Shell> drvcfg -s drvr_handle cntrl_handle where:

•drvr_handle: The handle of the driver that controls the channel with the SCSI ID you want to display or change.

•cntrl_handle: The handle of the controller for the channel with the SCSI ID you want to display or change.

For channel A of this SCSI interface, enter:

Shell> drvcfg -s 45 18

5.The EFI SCSI Setup Utility starts and its main menu displays, showing a list of all the EFI capable SCSI interfaces in the system.

Move the cursor to highlight the channel of the SCSI interface. Press Enter to determine which channel of the interface to highlight, match the PCI Bus, PCI Dev, and PCI Func values on this screen to the Bus #, Dev #, and Fnc # values from the info io command.

CAUTION: Do not select the <Global Properties> option on the main menu.

TIP: To move the cursor in the EFI SCSI Setup Utility, use the following keys:

•Arrow keys: ↑ ↓ ← →

•Alternate keys:

H = left

J = down

K = up

L = right

I = home

O = end

6.The Adapter Properties screen for this channel of the SCSI interface displays. Be sure the utility is running for the channel of the SCSI interface by comparing the values shown for

Specifying SCSI Parameters 341