8.Use the LC command to disable DHCP.
a.From the LC command menu, type D and press Enter.
b.Follow the instructions on the screen to change the DHCP status from Enabled to Disabled.
c.Enter XD
9.Use the LC command to enter information for the IP address, host, subnet mask, gateway parameters, and so on.
10.Enter XD
11.After the iLO 2 MP resets, log in to the iLO 2 MP again and enter CM at the MP:> prompt.
12.Enter LS to confirm that DHCP is disabled and display a list of updated LAN configuration settings.
Logging In to the iLO 2 MPTo log in to the iLO 2 MP, follow these steps:
1.Access the iLO 2 MP using the LAN,
2.Log in using the default the iLO 2 MP user name and password (Admin/Admin).
TIP: For security reasons, HP strongly recommends you modify the default settings during the initial login session. See “Modifying User Accounts and Default Password” (page 89).
Following is the MP Main Menu:
iLO MP MAIN MENU:
CO: | Console |
VFP: | Virtual Front Panel |
CM: | Command Menu |
CL: | Console Logs |
SL: | Show Event Logs |
SMCLP: | Server Management Command Line Protocol |
HE: | Main Menu Help |
X:Exit Connection
See the HP Integrity Integrated
When logging in using the local or remote
This section provides additional information to setup the iLO 2 MP.
Modifying User Accounts and Default Password
The iLO 2 MP comes preconfigured with default factory settings, including a default user account and password. The two default user accounts on initial login are:
•All Rights (Administrator) level user: login = Admin
password = Admin
•Console Rights (Operator) level user: login = Oper
password = Oper
Console Setup | 89 |