Installing Additional Components
This section describes how to install components into the server that are not factory integrated. Most servers are
This section addresses the following topics:
•“Removing and Replacing the Top Cover” (page 56)
•“Removing and Replacing the Memory Carrier Assembly Cover” (page 57)
•“Installing a
•“Removing and Replacing
•“Installing a
•“Installing a
•“Removing and Replacing the Memory Carrier Assembly” (page 65)
•“Installing System Memory DIMMs” (page 67)
•“Removing and Replacing the Processor Board Assembly” (page 73)
•“Installing a
Removing and Replacing the Top Cover
This section describes how to remove and replace the server’s top cover.
Removing the Top Cover
To remove the top cover, follow these steps:
1.Unlock the cover release lever (Figure
2.Pull up on the cover release lever to disengage the top cover from the chassis (Figure
NOTE: The cover release lever also disengages the memory carrier assembly cover.
The memory carrier assembly cover can remain in place while servicing any components except for the memory carrier assembly and the processor board assembly.
3.Slide the cover toward the rear of the server until the tabs release from the slots in the chassis.
4.Lift the cover off the chassis.
56 Installing the System