NOTE: The extraction handles latch into the open position with an audible click.

6.Pull the extraction handles to lift the memory carrier assembly out of the chassis (Figure 6-12).

NOTE: To avoid damage to the extraction handles, HP recommends rotating the handles inward and snapping them into the locked position when servicing the system DIMMs or any time the carrier is out of the chassis. Before replacing the memory carrier, press the button to release the extraction handles. Use the handles to replace the memory carrier into the chassis.

Figure 6-12 Removing and Replacing the Memory Carrier Assembly

Extraction Handles

Extraction Handle

Release Button

Front Bezel

 

Processor Board Assembly

Front Chassis

Access Door

Guide Slot

 

Replacing the Memory Carrier Assembly

CAUTION: Ensure the processor board assembly is fully seated before you replace the memory carrier assembly. The processor board assembly access door must be flush with the front bezel.

To replace the memory carrier assembly, follow these steps:

1.Ensure that the extraction handles are positioned in the outward, unlocked position.

2.Align the memory carrier assembly with the front and rear chassis guide slots.

Removing and Replacing the Memory Carrier Assembly 205