•Secure the impeller assembly to the crankshaft using the hex bolt, lock washer, and flat washer previously removed. Torque the bolt to 550 in. lbs. to 700 in. lbs.
•Place the housing blades against the inner housing. See Figure 16.
Inner |
Housing |
Housing |
Blades |
Figure 16
•Place the outer housing against the inner housing. Insert two screwdrivers into the holes to hold the blades in place while attaching the outer housing. See Figure 17.
•Secure with the fourteen self tapping screws that were previously removed and insert all screws first before tightening.
•Reassembled following the previous steps in reverse order.
Outer |
Housing |
Holes for |
Screwdrivers |
Figure 17
Storing Your Chipper Shredder Vacuum
•Clean the equipment thoroughly.
•Wipe equipment with an oiled rag to prevent rust.
•Refer to engine manual for correct engine storage instructions
•Store unit in a clean, dry area. Do not store next to corrosive materials such as fertilizer.
WARNING: Never store the machine or fuel container indoors where there is an open flame, spark, or pilot light such as on a water heater, furnace, clothes dryer, or other gas appliance.
13
