MTD 31AH553G401 manual To Stop Engine

Traction Drive/Auger Clutch Lock

The traction drive clutch is located on the right handle. Squeeze the traction drive clutch to engage the wheel drive. Release to stop.

This same lever also locks the auger clutch to avoid interruption of the snow throwing process. If the auger drive clutch is engaged with the traction drive clutch engaged, the operator can release the auger drive clutch (on the left handle) and the augers will remain engaged. Release the traction drive clutch to stop both the augers and wheel drive (auger drive clutch must also be released).

Headlight

The headlight is on whenever the engine is running.

Safety Ignition Switch

The ignition key must be inserted completely in the switch before the unit will start. Do not attempt to turn the key.

Fuel Shut-Off Valve

The fuel shut-off valve, located under the fuel tank, controls fuel flow from tank. Make sure it is not turned off before starting the engine.

Electric Chute Rotation Switch

The electric chute-rotation switch is located on the left side of the snow thrower dash panel.To change the direction in which discharged snow is thrown, proceed as follows:

•Push the toggle switch to the left to rotate the chute counter-clockwise.

•Push the toggle switch to the right to rotate the chute clockwise.

IMPORTANT: Release the switch once the chute has completed its rotation cycle in either direction. Failure to do so can result in damage to the electric chute motor and/or its drive gear.

Chute Tilt Control

The distance snow is thrown can be adjusted by adjusting the angle of the chute assembly. Move the chute tilt control forward to decrease the distance, and towards the rear to increase the distance.

Stay Warm Handles Switch

This switch is located on the right side of the snow thrower dash panel. To activate the Stay Warm handles, toggle the switch to the right to generate heat within the handle grips. Toggle the switch to the left to the OFF position after using the snow thrower.

NOTE: The Stay Warm grips are a compliment to, not a substitute for, proper cold weather outerwear for the operator’s hands. It is recommended that the snow thrower operator wear gloves/mittens to avoid extremities of winter while operating this equipment.

To Stop Engine

CAUTION: If for some reason, the unit starts accidentally while the operator is getting aquainted with the controls listed above, stop the engine immediately.

•To stop engine, push the throttle lever all the way down, or remove the ignition key. Do not turn key.

8