engine pulley. Replace by using the same proce- | 9.2. Remove the pulley. See Figure 13. |
dure. See Figure 11. |
|
Pull down on idler arm
Brake Shoe
Figure 11
9.AUGER REMOVAL
9.1.Place a two by four wedge in the housing to hold the auger from turning. Using 1” socket, remove the auger pulley nut. The shaft is reverse threaded and the nut is removed by turning it clockwise. See Figure 12.
2x4 Wedge
Figure 12
NOTE: During reassembly place the 2X4 at the base of the housing center and tighten in the opposite direction.
Figure 13
9.3.Using a 3/8” socket, remove the three retaining screws securing the bearing retainer housing to the auger housing. See Figure 14.
Bearing Retainer Housing
Figure 14
4