When using the tiller for the first time, use the second adjustment hole from the top (1" of tilling depth). See Figure 9.

Use This Position

Transport Position

First Time

 

1”

Clevis Pin

3”

 

 

5”

 

7”

Use This Hole For

 

Lowest (Shallowest)

 

Position

Side Shields

 

 

Use This Hole For

 

Highest (Deepest)

 

Position

Figure 9

When breaking up sod and for shallow cultivation, use the setting which gives 1" of tilling depth (second hole from the top). Place the side shields in their lowest position.

For further depth, raise the depth stake and side shields and also make one or two more passes over the area.

When tilling loose soil, the depth stake may be raised to its highest position (use bottom adjustment hole) to give the deepest tilling depth. Raise the side shields to their highest position.

To transport tiller, lower the depth stake (use top adjustment hole).

To adjust the depth stake, remove the clevis pin and hairpin clip. Move the depth stake to the desired setting and secure with the clevis pin and hairpin clip.

See Figure 9.

To adjust the side shields, remove the wing nuts. Move the side shield to the desired position and replace the wing nuts. Tighten securely.

Operating the Tiller

Select the depth stake setting.

Start engine as instructed on the previous page.

Move gear selection handle to one of the forward modes or reverse.

WARNING: Do not move the gear selection handle with the wheels or tines engaged. Make certain the unit is stopped completely before changing the gear selection. A partial engagement may be necessary when engaging tines.

Squeeze the clutch handle against the handle to engage the wheels and tines.

NOTE: Make certain the gear selection indicator is correctly positioned before engaging the clutch handle. If it is between gears, the engine will stall.

To transport tiller, do not engage the tines. Select the wheel drive only.

WARNING: Do not push down on the handles so that the wheels are lifted off the ground while using the tine drive, or the tiller could move backward and cause personal injury.

For best results, it is recommended the garden be tilled twice (lengthwise, then widthwise) to pulverize the soil.

11

Page 11
Image 11
MTD 428C manual Operating the Tiller