SECTION 2: ASSEMBLING YOUR TILLER
NOTE: This operator’s manual covers various models of tillers. The units illustrated may vary slightly from your unit. Follow only those instructions which pertain to your model number.
NOTE: References to right or left side of the tiller are determined from behind the unit in the operating position.
To Remove Unit From Carton
•Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open carton.
•Remove loose parts included with unit (i.e., operator’s manual, etc.).
•Cut corners and lay carton down flat.
•Remove packing material.
•Roll or slide unit out of carton. Check carton thoroughly for loose parts.
•Extend control cable and lay on the floor. Be careful not to bend or kink control cable.
IMPORTANT: This unit is shipped without gasoline or oil in the engine. Be certain to service engine with gasoline and oil as instructed in the separate engine manual before operating your machine.
Loose Parts In Carton
Depth Stake
Handle Assembly
Shift Rod
NOTE: All hardware needed for assembly is attached to the loose parts or the tiller.
Before Assembly
WARNING: Disconnect the spark plug wire and ground it against the engine to prevent unintended starting.
Attaching Depth Stake
•Tip the tiller forward so it rests on front counterweight.
•Unthread the “T” knob from the top of the depth stake and remove the flat washer and hex bolt. Remove the hairpin clip from the clevis pin.
See Figure 1.
•Raise the tine shield hinge flap assembly and insert the depth stake assembly in the slot (under the tine shield) and up through the tine shield assembly.
•Insert clevis pin through the tine shield and depth stake assemblies. Secure with hairpin clip.
•Insert hex bolt into the top hole of the depth stake assembly. Place flat washer on the hex bolt and thread “T” knob onto the hex bolt. Tighten securely. See Figure 1.
•Tip the tiller back down so it rests on the tines.
Flat Washer | Hex Bolt |
| |
| Hairpin Clip |
Clevis Pin |
|
Depth Stake |
|
Figure 1
Attaching Handle Assembly
•Remove the handle adjustment crank, flange nut, retainer bracket, shoulder bolt, and lock nut from the pivot bracket.
•Place the handle assembly in position in the handle pivot bracket lining the upper holes in the handle with the slots in the pivot bracket. See Figure 2.
Retainer Bracket, |
Shoulder Bolt, & Lock Nut |
Handle Adjustment Crank |
and Flange Nut |
Pivot Bracket |
Figure 2
•Lift up the handle assembly and align the bottom holes in the handle assembly with the holes in the pivot bracket. Insert shoulder bolt from the left side of unit through the pivot bracket and the retainer bracket on the right hand side of the unit.
See Figure 3.
5
