To shift into forward wheels and tine drive, push forward slightly on the gear selection handle and slowly engage the clutch control allowing the gears to synchronize. To stop forward movement and tine drive, release the clutch control. Do not shift gears with the clutch control engaged except when engaging the tines.
WARNING: Make certain unit is in NEUTRAL when starting the engine.
Clutch Control
The clutch control is located beneath the handle. Squeezing the clutch control against the handle engages the wheel and tine drive mechanisms.
NOTE: Never engage clutch lever while shifting.
Throttle Control
The throttle control lever is located on the engine. It controls the engine speed and stops the engine.
Choke Lever (If Equipped)
The choke lever is located by the throttle. It is used to enrich the fuel mixture in the carburetor when starting a cold engine.
Primer Button (If Equipped)
The primer button is located behind the air cleaner. It is used to enrich the fuel mixture in the carburetor when starting a cold engine.
Depth Stake
The depth stake controls the tilling depth. Refer to ‘‘Setting the Depth’’ in the Operating Section.
Handle Adjustment Lock
The handle may be adjusted to the height desired. Loosen the handle height adjustment lock a few turns. Pivot handle up or down to desired position. Tighten lock.
Engine Controls
See the separate engine manual for additional information and functions of the engine controls.
SECTION 4: OPERATING YOUR TILLER
WARNING: Read, understand, and follow all instructions and warnings on the machine and in this manual before operating.
Before Starting
Gas And Oil
Service the engine with gasoline and oil as instructed in the separate engine manual packed with your tiller. Read instructions carefully.
WARNING: Use extreme care when handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel machine indoors or while the engine is hot or running.
Starting Engine
NOTE: When pushing the unit with the engine off, you will hear a ratcheting sound (gear noise) which is normal.
WARNING: Be sure no one is standing in front of the tiller while the engine is running or being started.
•Place gear selection lever in NEUTRAL.
•Place the throttle control lever in FAST position or if equipped, place the engine speed control in the START position.
•Move choke lever to CHOKE position or if equipped, push primer two (2) or three (3) times. Wait about two (2) seconds between each push.
NOTE: A warm engine may not require choking or to be primed.
•Stand at side of tiller. Grasp the starter handle and pull out slowly, until it pulls slightly harder. Let rope rewind slowly.
•Pull starter handle rapidly. Do not allow handle to snap back. Allow it to rewind slowly while keeping a firm hold on the starter handle.
•Repeat previous steps until engine starts.
•As engine warms up and begins to operate evenly, move choke lever gradually to RUN position. If engine falters, return to choke position, then slowly move to RUN position.
•Refer to engine manual for additional engine information.
NOTE: After starting and prior to using the tiller for the first time, be certain to check the clutch adjustment as described in “Checking the Clutch Adjustment” section of the Assembly Instructions.
8
