b.Place second spacer over hex bolt inside other hinge and secure with hex lock nut.
c.Secure both sides of chute deflector to impeller housing using wing knobs previously removed.
Attaching The Chipper Chute
5.a. Remove the three cupped washers and hex nuts from weld studs around the opening on the side of the impeller housing. See Figure 5.
b.Remove the hex bolts, flat washers, and lock nuts from the two holes on the upper end of the support brace.
6.a. Align the chipper chute over the weld studs, so the slot in the bottom of the chute is facing down.
b.Secure chipper chute with the three cupped washers (cupped side against the chipper chute) and hex nuts previously removed. Do not tighten the nuts at this time. See Figure 6.
7.The chipper shredder was shipped with one end of the support brace already secured to the lower frame. Loosen but do not remove the bolts securing the brace to the frame. See Figure 7.
a.Align the holes in the chute with the holes in the top of the brace and attach brace to chipper chute with hardware previously removed. Tighten securely.
b.Tighten the bolts securing the support brace to the frame.
c.Tighten the three nuts on the weld studs holding the chipper chute to the impeller housing.
Attaching The Bag
8.To attach the bag:
a.Place the opening of the bag completely over the chute deflector.
b.Pull on the drawstring until the bag is tight around chute deflector opening.
c.Clip drawstring back on itself, tight against chute deflector to secure into position. See Figure 8.
�
�
Figure 5
� 
�
Figure 6
3
Setting Up
Your Chipper
Shredder
� | � |
|
�
� 
�
�
Figure 8 | Figure 7 |
7
