S30039
>76mm
S30186
SECTION 2: ASSEMBLING YOUR CHIPPER SHREDDER
IMPORTANT: This unit is shipped WITHOUT GASOLINE or OIL in the engine. Be certain to service engine with gasoline and oil as instructed in the separate engine manual before operating your machine.
NOTE: Reference to right or left hand side of the chipper shredder is observed from the operating position.
Removing Unit From Carton
•Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open carton.
•Remove loose parts if included with unit (i.e., operator’s manual, etc.)
•Cut along corners, lay carton down flat, and remove packing material.
•Roll or slide unit out of carton and check carton thoroughly for loose parts.
Loose Parts In Carton (See Figure 1)
•Hopper Assembly
•Discharge Chute
•Chipper Chute (462 thru 465)
•Bag (Not Shown)
•Tamper Plug (If Equipped)
•Safety Glasses (Not Shown)
Disconnecting Spark Plug Wire
Before setting up your chipper shredder, disconnect the spark plug wire from the spark plug and ground against the engine.
5
