NOTE: Each end of the lower handle must be placed in the same position on the mounting brackets.

a.Remove the star knobs shown in Fig. 3-3 and remove the lower handle.

4.Use the cable tie provided to secure cable to the lower handle. Pull the cable tie tight and trim excess. See Fig. 3-5.

Figure 3-3

b.Position each handle bracket stud into the top hole in the lower handle.

c.Tighten the star knobs.

3.Position the recoil starter by following the steps below:

a.Hold the blade control against the upper handle.

b.Slowly pull the starter rope out of the engine. See Fig. 3-4.

A

B D

C

Figure 3-4

c.Slip the starter rope into the rope guide.

d.Tighten the rope guide wing nut.

Figure 3-5

Rear Wheels

Install rear wheels as follows in Fig. 3-6 (wheels maybe already installed at factory, if so disregard this step):

Figure 3-6

1.Place rear of the mower deck on raised blocks.

2.Remove lock nut from pivot arm assembly (on select models, these may be included separately in a plastic bag).

3.Slide wheel, with hollow side in, onto pivot arm and secure with lock nut.

4.Assemble the other side in the same manner.

Section 3 — Assembly & Set-Up

 

9