Safety Labels Found On Your Log Splitter

Safety Labels Found On Your Log Splitter

��	��
��	��
��
��	��
��	��
��

��

Safety Labels

��		��
��	��
	��
	��
	��
	��
	�	��
	��
	�	��
	��
	��
	�
		��

��

� ��

��

� ��

��

� ��

WARNING

DO NOT remove safety (or any) labels from log splitter for any reason.

��

��		��	��
��		�	��
		��
��		�	��
��
		��	��
��	��	��
		�	��
��
��		��
		�	��
��
�	��

Page 3

Image 3

MTD 510 warranty Safety Labels Found On Your Log Splitter

Contents

Log Splitter Model MTD LLC, P.O. BOX 361131 CLEVELAND, Ohio04/25/2006 Table of Contents Finding and Recording Model NumberCustomer Support Engine Information Safety Labels Found On Your Log Splitter Your Responsibility General PracticesPreparation Do not tow machine faster than 45mph Maintenance and StorageOperation Use only your hand to operate the controls Attaching the Jack Stand Setting Up Your Log SplitterConnecting Cylinder to Beam Assembling the Tongue Preparing the Log Splitter Support latch bracket. See Figure Know Your Log SplitterBeam Locks Engine Controls Function of the controls on the engine Starting Engine Stopping EngineGas and Oil Fill-Up Control Handle Using the Log Splitter Before Each UseOperating Tips Never Raising and Lowering BeamTransporting the Log Splitter Split wood along the grain lengthwise only Adjustment Bolt Jam Nut Gib Lock Nut Gib AdjustmentWedge Assembly Adjustment Conditions that Will Void Warranty Engine Hydraulic Fluid and Inlet FilterBeam and Splitting Wedge Hose Clamps Side View-Coupler 0600 Install nylon spider onto engine coupling halfTires Set Screw Replace spark plug Storing Your Log Splitter Cause Remedy Problem Cause Remedy Retracting Engine stalls during Low horsepower/weak engineService dealer Conditions Low horsepower/weak engine Model Hex Cap Screw 3/8-24 x Wedge AssemblyHydraulic Cylinder 712-3058 Hex Lock Nut, 1/2-20 712-0711 Hex Jam Nut 3/8-24 MTD LLC, P.O. BOX 361131 CLEVELAND, Ohio 44136-0019 Phone MANUFACTURER’S Limited Warranty for