Lock Washer
Hex Bolt(C)
(B)
Saddle
(I)
Hex Bolt (A)
Lock Washer (C)
Figure 4
Pivot Rod
Cover Tube
ATTACHING THE HANDLES (Hardware A)
1.Place right handle in position against the snow thrower so the flat side of the handle is against the frame. Secure bottom hole in handle to snow thrower using hex bolt (B) and lock washer (C). There are weld nuts welded to the inside of the frame for these bolts. See Figure 4. Do not tighten at this time.
2.Attach the left handle in the same manner. Do not tighten at this time.
3.Place saddle (I) over upper holes on handles (curve matching curve on handle). Secure to the frame with lock washers (C) and hex bolts
(A). See Figure 4. Do not tighten at this time.
ATTACHING THE CLUTCH GRIPS
(Hardware B)
1.Slide the pivot rod into the cover tube as shown in Figure 5. The pivot rod and cover tube may already be assembled.
Figure 5
Clutch
Grips
Hex Nuts (D)
Figure 6
Clutch Grip and
Rod Assembly
Handle
Tab
Hex Nut (D)
Figure 7
2.Place the clutch grips in position on the rod so the flat side of the clutch grips are against the pivot rod cover. Thread hex nuts (D) onto each end of the rod. Tighten nuts allowing the clutch grips to move freely on pivot rod. See Figure 6.
3.Insert clutch grip and rod assembly into handle tabs. Clutch grips must sit on top of the handles. Thread hex nuts (D) on each end to hold into position. Do not tighten. See Figure 7.
7
