SECTION 5: MAKING ADJUSTMENTS
WARNING: NEVER attempt to make any adjustments while the engine is running, except where specified in the operator’s manual.
Tire Pressure (Pneumatic Tires)
•The tires are overinflated for shipping purposes. Before operating check tire pressure and reduce pressure to between 15psi and 20 psi.
NOTE: If the tire pressure is not equal in both tires, the unit may pull to one side or the other.
Traction Control and Shift Lever
To check the adjustment of the traction control and shift lever, proceed as follows:
•To check the adjustment of the traction control clutch and shift lever, proceed as follows:
•With the engine off, move the shift lever all the way forward to the highest speed. With the traction control lever released, push the snow thrower forward. The unit should roll forward. Then engage the traction control grip. The wheels should stop turning.
•Now release the traction control grip and push the unit again.
•Move the shift lever back to the fast reverse position then all the way forward again. There should be no resistance in the shift lever, and the wheels should keep turning.
•If you have resistance when moving the shift lever or the wheels stop when they should not, loosen the jam nut on the traction control cable and unthread the cable one turn.
•If the wheels do not stop when you engage the traction control clutch grip, loosen the jam nut on the traction control cable and thread the cable in one turn.
•Recheck the adjustment and repeat as necessary. Tighten the jam nut to secure the cable when correct adjustment is reached.
WARNING: Drain the gasoline out of the snow thrower’s tank, or place a piece of plastic film under the gas cap to avoid spillage BEFORE making the adjustment.
To test further for correct adjustment, if necessary, proceed as follows:
•Tip the snow thrower forward, allowing it to rest on the auger housing. See Figure 8.
Frame Cover |
Auger |
Housing |
Figure 8
•Remove the frame cover underneath the snow thrower by removing the six
•With the traction control released, there must be clearance between the friction wheel and the drive plate in all positions of the shift lever.
•With the traction control engaged, the friction wheel must contact the drive plate. See Figure 9.
If adjustment is necessary:
•Loosen the jam nut on the traction drive cable and adjust the cable as necessary. Refer to Figure 6.
•Retighten the jam nut to secure the cable when correct adjustment is reached.
•Reassemble the frame cover.
NOTE: If you placed plastic film under the gas cap earlier, remove it now.
Sprocket | Axle Shaft |
| |
Gear | Chain |
| |
Shaft |
|
Friction | Drive Plate |
| |
Wheel |
|
Figure 9
10
