Assembly & Set-Up

3

 

 

 

Contents of Carton

 

•

Two Ignition Keys

•

One 2.6 oz. Bottle of Two Cycle Oil

•

One Extension Cord (if equipped)

•

One Snow Thrower Operator’s

•

One Tecumseh Engine Operator’s

•

One Product Registration Card

 

Manual

 

Manual

 

 

NOTE: This Operator’s Manual covers several models. Snow thrower features may vary by model. Not all features in this manual are applicable to all snow thrower models.

Assembly

Positioning the Upper Handle

1.Making sure not to pinch the cable in the process, pivot the upper handle into the operating position as illustrated in Fig. 3-1 until it clicks into place.

Figure 3-1

2.Tighten the wing knobs to secure the handle in place. See Fig. 3-1.

Assembling the Discharge Chute

For shipping reasons, the snow thrower has been packaged with the upper chute pivoted all the way down. To pivot it upward, proceed as follows:

1.Remove the wing knob, flat washer and carriage bolt from the lower chute. See Fig. 3-2.

Figure 3-2

2.Pivot the upper chute upward over the lip on the lower chute so that there is no gap between the upper chute and the lower chute.

3.Secure with the hardware just removed. Refer to Fig. 3-3.

Chute Handle

Figure 3-3