![](/images/new-backgrounds/1167577/16757729x1.webp)
Auger Belt Replacement
To remove and replace your snow thrower’s auger belt, proceed as follows:
1.Remove the plastic belt cover on the front of the engine by removing the two
Figure
Figure
Figure
NOTE: Drain the gasoline from the snow thrower, or place a piece of plastic under the gas cap.
2.Carefully pivot the snow thrower up and forward so that it rests on the auger housing. Remove the frame cover from the underside of the snow thrower by removing four
3.Roll the auger belt off the engine pulley. See Figure 6-6.
4.a. Loosen and remove the shoulder screw which acts as a belt keeper. See Figure
b.Unhook the support bracket spring from the frame.
5.Remove the belt from around the auger pulley, and slip the belt between the support bracket and the auger pulley. Reassemble auger belt by following instructions in reverse order. See Figure
NOTE: Do NOT forget to reinstall the shoulder screw and reconnect the spring to the frame after installing a replacement auger belt and to remove the piece of plastic from under the gas cap.
Figure
Figure
6
Maintaining
Your Snow
Thrower
NOTE: Although
NOTE: Do not sand- blast spark plug. Spark plug should be cleaned by scraping or wire brushing and washing with a commercial solvent.
IMPORTANT NEVER replace the auger shear pins with standard pins. Any damage to the auger gearbox or other com- ponents, as a result of doing so, will NOT be covered by your snow thrower’s warranty.
15