Service | 7 |
| |
|
|
Cutting Deck Removal
NOTE: Models equipped with a
To remove the cutting deck, proceed as follows:
1.Place the PTO (Blade Engage) lever in the disengaged (OFF) position and engage the parking brake.
2.Lower the deck by moving the deck lift lever into the bottom notch on the right fender.
3.Remove the
Note: Make a mental note what hole the other end of the belt- keeper rod is inserted in for reinstallation purposes.
C | A |
| |
| B |
Figure
4.Remove the belt (C) from around the tractor’s engine pulley. See Fig.
5.Looking at the cutting deck from the left side of the tractor, locate the cotter pin that secures the deck support rod
on the rear left side of the deck. See Fig.
6.Repeat the above steps on the tractor’s right side.
NOTE: The deck support rod on the right side of the tractor is secured using hair pin clip as opposed to a cotter pin, which you might had noticed was used on the left side. This is normal and should be reinstalled in the same manner as removed.
7.Move the deck lift lever into the top notch on the right fender to raise the deck lift arms up and out of the way.
8.Gently slide the cutting deck toward the front of the tractor carefully guiding the hooks on the deck off of the deck stabilizer rod.
Figure
9.Carefully remove the PTO cable from the rear of the cutting deck by removing the hair pin clip which secures it. Remove the spring from the deck idler bracket. See Fig.
Figure
10.Gently slide the cutting deck (from the left side) out from underneath the tractor.
23