2.Remove the T-bolts from the handle brackets as shown in Fig. 3-3.

C

C

Figure 3-3

3.Follow the steps below to complete handle assembly:

a.Pull upward on the handle until holes in lower handle (shown in Fig. 3-3 deck cutaway) line up with holes in handle bracket. See Fig. 3-4.

Figure 3-5

4.The rope guide is attached to the right side of the upper handle. Loosen the wing knob which secures the rope guide. See Fig. 3-6.

a.Hold blade control against upper handle.

b.Slowly pull starter rope handle from engine and slip starter rope into the rope guide. See Fig. 3-6.

A B

B

Figure 3-4

NOTE: When pulling upward on handle, make sure to not pull handle all the way out.

b.Insert the T-bolts removed earlier through the handle brackets and lower handle and tighten securely to secure the handle in place. See Fig. 3-4.

c.Reattach wing nuts and carriage bolts removed earlier into lower holes of handle as shown in Fig. 3-5.

A

D

B

C

Figure 3-6

c.Tighten rope guide wing knob.

d.Use cable tie(s) to secure cable(s) to lower handle.

Grass Catcher (If Equipped)

1.Follow steps below to assemble the grass catcher (if needed). Make certain bag is turned right side out before assembling (warning label will be on the outside).

a.Place bag over frame so that its black plastic side is at the bottom.

10Section 3 — Assembly & Set-Up