SECTION 8: TROUBLESHOOTING GUIDE
Problem |
| Cause |
| Remedy |
|
|
|
|
|
Engine fails to start | 1. | Key not in ignition switch or not in ON position. | 1. | Insert key and turn to ON position |
| 2. | Fuel tank empty, or stale fuel | 2. | Fill tank with clean fresh gasoline/oil |
|
|
|
| mixture as specified in the engine manual. |
| 3. | Blocked fuel line | 3. | Clean fuel line |
| 4. | Spark plug wire disconnected | 4. | Connect wire to spark plug. |
| 5. | Faulty spark plug | 5. | Clean spark plug, readjust gap, or replace. |
Engine runs erratic | 1. | Unit running on choke | 1. | Move choke lever to off position. |
| 2. | Fuel line blocked, or stale fuel | 2. | Clean fuel line and fill tank with fresh, clean |
|
|
|
| gasoline. |
| 3. | Water or dirt in fuel system | 3. | Refer to engine manual on remedy. |
| 4. | Carburetor out of adjustment | 4. | Refer to engine manual. |
Loss of power | 1. | Spark plug wire loose | 1. | Connect and tighten spark plug wire. |
| 2. | Vent in fuel cap plugged | 2. | Clear vent. |
| 3. | Engine exhaust pipe plugged. | 3. | Remove obstruction from exhaust pipe. |
Excessive vibration | 1. | Loose parts or damaged auger | 1. | Stop engine immediately and disconnect |
|
|
|
| spark plug wire. Check for possible |
|
|
|
| damage. Tighten all bolts and nuts. Repair |
|
|
|
| as needed. If the problem persists, take unit |
|
|
|
| to an authorized MTD service dealer. |
Unit fails to | 1. | Drive cable out of adjustment | 1. | Adjust the control cable as instructed on |
|
|
|
| page 9 of this manual. |
| 2. | Drive belt damaged | 2. | Inspect the drive belt for damage and |
|
|
|
| replace if necessary as instructed on page |
|
|
|
| 10 of this manual. |
Unit fails to discharge | 1. | Discharge chute clogged | 1. | Stop engine immediately and disconnect |
snow |
|
|
| spark plug wire. Clean discharge chute and |
|
|
|
| the auger housing. |
| 2. | Foreign object lodged in auger | 2. | Stop engine immediately and disconnect |
|
|
|
| spark plug wire. Remove object. |
| 3. | Drive cable out of adjustment | 3. Adjust the control cable as instructed | |
| 4. | Drive belt or damaged |
| on page 9 of this manual. |
| 4. | Inspect the drive belt for damage and | ||
|
|
|
| replace if necessary as instructed on page |
|
|
|
| 10 of this manual. |
SECTION 9: ACCESSORIES & KITS
The following accessories and kits are available for
MODEL | DESCRIPTION |
|
|
Electric Start Kit | |
| (fits models with a |
Electric Start Kit | |
| (fits models with a |
MTD | |
Shave Plate (includes replacement shave plate and hardware) | |
Auger Rubber Paddle Kit (includes replacement rubber paddles and hardware) | |
|
|
12