SECTION 2: ASSEMBLING YOUR SNOW THROWER
NOTE: This Operator’s Manual covers several models.
Snow thrower features vary by model. Not all features discussed in this manual are applicable to all snow thrower models.
•Raise the upper handle in the direction shown in Figure 1 until it clicks into the operating position. Make sure not to pinch or crimp the cable.
•Tighten the hand knobs.
Unpacking From Carton
•Cut along corners of the carton and lay it down flat. Remove packing material.
•Remove any loose parts included with unit (i.e., operator’s manual, etc.).
•Roll unit out of carton. Check carton thoroughly for any remaining loose part.
Items Required For Assembly
1.Engine oil
2.Fresh gasoline
NOTE: All references to left or right side of the snow thrower is from the operating position only.
Before Assembly
WARNING: Disconnect the spark plug wire and ground it against the engine to prevent unintended starting. Refer to the separate engine manual packed with your unit.
Raising Upper Handle
•Loosen the hand knob on each side of the handle. Remove packing material, if any.
Hand Knob |
Spark Plug |
Access |
Figure 1
Assembling the Discharge Chute
For shipping reasons, the snow thrower has been packaged with the upper chute pivoted all the way down as shown in Figure 2. To pivot it upward, proceed as follows:
1.Turn the chute until the chute opening is facing straight ahead.
2.Remove the wing knob, flat washer and carriage bolt from the lower chute.
3.Pivot the upper chute upward over the lip on the lower chute so that there is NO gap between the upper chute and the lower chute.
4.Resecure with the hardware just removed.
CAUTION: Do not use the Chute
Handle to lift the machine.
3
4
2
1
Figure 2
5
