MTD E740, E760 manual To Stop Engine, To Engage Drive, To Engage Augers, Operating Tips

TO STOP ENGINE

1.Run engine for a few minutes before stopping to help dry off any moisture on the engine.

2.To help prevent possible freeze-up of starter, proceed as follows.

Connect power cord to switch box on engine, then to 120 volt AC receptacle. With the engine running, push starter button and spin the starter for several seconds. The unusual sound made by spinning the starter will not harm engine or starter. Disconnect the power cord from receptacle first, and then from switch box.

Recoil Starter (Optional Instructions): With engine running, pull starter rope with a rapid, continuous full arm stroke three or four times. Pulling the starter rope will produce a loud clattering sound, which is not harmful to the engine or starter.

3.To stop engine, remove the ignition key. Do not turn key. Disconnect the spark plug wire from the spark plug to prevent accidental starting while equipment is unattended.

NOTE: Do not lose ignition key. Keep it in a safe place. Engine will not start without the ignition key.

4.Wipe all snow and moisture from the carburetor cover in the area of the control levers. Also, move control levers back and forth several times. Leave throttle control lever in the STOP or OFF position. Leave choke control in the FULL choke position.

SHUT OFF ENGINE

BEFORE UNCLOG-

GING DISCHARGE

CHUTE.

5784

TO ENGAGE DRIVE

1.With the engine running near top speed, move shift lever into one of the six FORWARD positions or two REVERSE positions. Select a speed appropriate for the snow conditions that exist. Use the slower speeds until you are familiar with the operation of the snow thrower.

2.Squeeze the traction drive clutch grip against the right handle and the snow thrower will move. Release it and the drive motion will stop.

NOTE: NEVER move shift lever without first releasing the drive clutch.

TO ENGAGE AUGERS

To engage the augers and start the snow throwing action, squeeze the auger clutch grip against the left handle. Release to stop the augers (traction drive clutch grip must also be released).

The auger drive clutch can also be locked so you can turn the chute crank without interrupting the snow throwing process. Refer to “Traction Drive/ Auger Clutch Lock” in the Control section.

OPERATING TIPS

NOTE: Allow the engine to warm up for a few minutes as the engine will not develop full power until it reaches operating temperature.

WARNING: Temperature of muffler and surrounding areas may exceed 150oF. Avoid these areas.

1.For most efficient snow removal, remove snow immediately after it falls.

2.Discharge snow downwind whenever possible. Slightly overlap each previous swath.

3.Set the skid shoes 1/4" below the scraper bar for normal usage. The skid shoes may be adjusted upward for hard-packed snow. Adjust downward when using on gravel or crushed rock.

4.Be certain to follow the precautions listed under ‘‘To Stop Engine’’ on page 12 to prevent possible freeze-up.

5.Clean the snow thrower thoroughly after each use.

12